|Metal Building for Alexandria, Louisiana
Build and Buy Online!
Concealed condensation is the most difficult to deal with and can be the most damaging to any kind of structure. This type of condensation may be controlled in metal buildings by the proper ventilation. Additional condensation control can be accomplished by venting the cold cavities of the walls and roof.
Jamb Cover Trim
One of the trim options we offer is jamb cover trim. Though common, the red-iron jamb and header around a door opening are normally exposed. Using jamb cover trim is an inexpensive way to improve the appearance of your steel building.
What is a stronger material than metal? Metal frame buildings are nearly indestructible. You can certainly feel safe in even the worst weather in a metal frame structure.
Erecting a metal frame pre engineered building might sound like a difficult project, but despite this perception, it is really not the case. Metal frame structures are cut to precise measurements and a complete set of building plans will aid in the assembly process.
If you need help constructing your metal building, you will incur additional expenses, so be sure to factor construction cost into your budget when purchasing a steel building.
Labels on wall insulation rolls indicate the length as well as the number of pieces that need to be cut from each roll. We recommend that all rolls be cut from a clean location to avoid staining the insulation facing.
1) Cut the dimensions of the insulation from the base angle to eave strut or rake plus 6"-12" extra.
2) Attach one end of the insulation to the base angle using double-faced tape.
3) Pull from the other end to stretch the insulation tightly outside the girts to the eave or rake, and attach with double-faced tape.
4) Make sure the facing is toward the interior of the building and attach the panel to the structure.
5) Install the next roll in the same manner, with edges butted snugly. Then fasten the tabs using one of the methods described.
Secondary framing is created from rolled steel coated with a red-oxide primer finish in gages from 12 to 16 to provide an extremely rigid, and corrosion resistant structure. The following elements are formed as secondary framing:
Girts (walls) & Purlins (roof): These members run the length of the building providing rigidity, and a sturdy skeleton to attach the sheeting. They are rolled from steel coils 12,14 or 16-gauge steel, or thicker if needed. All girts and purlins are pre-punched for ease of assembly.
Eave Struts: This is a rolled member formed into a "C" to match the pitch of the roof. The eave strut is also made of 12, 14, or 16-gauge steel.Thank you for visiting Metal Building for Alexandria, Louisiana. We provide the best service and prices when shopping for metal buildings or steel buildings.